Take the 2-minute tour ×
Role-playing Games Stack Exchange is a question and answer site for gamemasters and players of tabletop, paper-and-pencil role-playing games. It's 100% free, no registration required.

In The Riddle of Steel on page 77 it notes that the maximum number of combatants that can surround a single opponent is three, except "groups of spearmen and the like, who may gather tightly together and thrust". The text nowhere mentions a limit to the number of spear-or-similar armed opponents who can surround one person.

How many spear-fighters can effectively attack a human-sized target at once? Failing a RAW-based answer, an answer based on historical accounts of the reality of spear fighting would certainly be in the spirit of the game.

share|improve this question

3 Answers 3

up vote 7 down vote accepted

I would say that it depends on the length of the spear. A unit using sarisa would be far more formidable than a unit using Hasta. Halberds would be in the middle but are used quiet differently from spears. Pikes again would be formidable to face as a single fighter against a unit. If said fighter was surrounded, the situation is even worst.

So, let's say your "spear" is 5 meters long. You have a circle of circumference of 2 * pi * 5 = 31.4. Assuming that a human (with amour) takes a "face" of .3 meters (sideways posture), you have 31.4/.3 = 104 people around your lone surrounded (and soon to be very dead) fighter.

Or, as Sean Cheshire says: If we use a single handed spear, then the calculation is 2 * pi * 2 / .3 = 41 people - still enough to do a lot of damage.

Technically, you could have any number of spheres (or an ovoid for more precision) of spears. From that point of view, the tip of the spear is the limiting factor. Those all need is an approximation of the dimensions of the target (minus 3/5 cm to allow for lethal penetration of each tip). This would depend on the shape of the tip, and how tightly you could pack them -- round tips are worst in this regard than square ones. This would massively increase the amount of fighters utterly surrounding the lone wolf.

Note 1: I would give a small penalty to the surrounding fighters as they are going to hinder each other a little (depending on training) but the final result is still going to be same: dead lone wolf.

Note 2: Combat in more than 3-dimensions is left as an exercise to the reader.

share|improve this answer
1  
Although you'd probably lose 1-1.5 metres off that 5m spear once you account for the amount needed to actually hold on to it. OTOH, you'd gain some of that back in arm extension once people start thrusting the spear. –  Vatine Jun 27 '12 at 9:34
    
@Vatine: Indeed. It is all approximations to give a reasonable number. –  Sardathrion Jun 27 '12 at 9:42
1  
@MichaelBorgwardt that's just people waiting to strike. –  Adriano Varoli Piazza Jun 27 '12 at 11:54
1  
the calculation seems to assume a two handed, or pike. If we use a single handed spear, then the calculation is 2 * pi * 2 / .3 = 41 people - still enough to do a lot of damage –  Sean Cheshire Jun 27 '12 at 13:08
1  
This answer is great, and does go a long way to explain why the text omits such a limit: by the time you're that surrounded, your Combat Pool would have to be split so far as to leave you completely defenseless! One request for completeness: could you expand your answer with another calculation for a short (say, 2.5m) spear, such as might be used one-handed? (Sean's numbers look good.) That would illustrate the range of "you are so dead" across most spear lengths. –  SevenSidedDie Jun 27 '12 at 16:45

How many spear-fighters can effectively attack a human-sized target at once?

More than it takes to kill any human-sized target that can be killed with spears at all.

Historically, spears were used either as (short) distance weapons, as a protection against cavalry charges, or in formations such as the Phalanx, where keeping the formation's (usually linear) shape was of paramount importance.

share|improve this answer

I first tried using 28mm miniatures to test this for you. I managed to get 9 spearmen to stab a single other 28mm miniature, but I had to take into account the width of the bases (which are larger than the size of a real man). I tried again with 1/72 miniatures and managed to get 11 spearmen to stab the same guy, but they had medieval pikes (1.5 times the size of the figure).

Historically a single spear thrust normally took down an unarmored foe, but in cases where a lot of spears were involved – i.e. a Phalanx – up to 4 or 5 guys could be spearing the same opponent simultaneously. This could of course increase should the foe be mounted; I have read, albeit in a fictional novel, that a horseman can be speared by a dozen men at one time.

Of course trying to thrust a spear when you have a warrior either side of you huddling around the same target would hinder your aim, strength and probably stability as Sadathrion said.

In LARP I've only ever seen 4 or 5 people effectively attack the same player. Anything past that and weapons start striking each other or the players start to get in each other's way.

share|improve this answer
1  
+1 for speaking from your experience. 104 spearmen would not even see the target (maybe transparent spearmen? ). –  Vorac Jul 4 '12 at 12:40
    
Transparent spearmen would maybe do it! ghosts, phantoms or spectres perhaps ? –  MavericktheBroken1 Jul 4 '12 at 13:00
1  
A phalanx of ghosts that pass through walls and hills? If the spears are not magical, I guess they will be able to just stab through their buddies, instead of overhead. Then we can have a line of bowmen behind them, shooting through them (and not overhead). ... –  Vorac Jul 4 '12 at 14:17
2  
This reminds me of that time I asked on an rpg forum "What are the penalties of shooting a gun through your buddy's shoulder." "Huge" - was the answer - "try shooting around his shoulder." –  Vorac Jul 4 '12 at 14:20

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.